doc/hardware/peripherals/sensor/device_tree.rst
Device Tree ###########
In the context of sensors device tree provides the initial hardware configuration for sensors on a per device level. Each device must specify a device tree binding in Zephyr, and ideally, a set of hardware configuration options for things such as channel power modes, data rates, filters, decimation, and scales. These can then be used in a boards devicetree to configure a sensor to its initial state.
.. code-block:: dts
#include <zephyr/dt-bindings/icm42688.h>
&spi0 { /* SPI bus options here, not shown */
accel_gyro0: icm42688p@0 {
compatible = "invensense,icm42688", "invensense,icm4268x";
reg = <0>;
int-gpios = <&pioc 6 GPIO_ACTIVE_HIGH>; /* SoC specific pin to select for interrupt line */
spi-max-frequency = <DT_FREQ_M(24)>; /* Maximum SPI bus frequency */
accel-pwr-mode = <ICM42688_ACCEL_LN>; /* Low noise mode */
accel-odr = <ICM42688_ACCEL_ODR_2000>; /* 2000 Hz sampling */
accel-fs = <ICM42688_ACCEL_FS_16>; /* 16G scale */
gyro-pwr-mode = <ICM42688_GYRO_LN>; /* Low noise mode */
gyro-odr = <ICM42688_GYRO_ODR_2000>; /* 2000 Hz sampling */
gyro-fs = <ICM42688_GYRO_FS_16>; /* 16G scale */
};
};