boards/silabs/explorer_kits/xg26/doc/pg26_ek2711a.rst
.. zephyr:board:: pg26_ek2711a
Overview
The EFM32PG26 Explorer Kit_ is a small form factor development and evaluation platform based on
the EFM32PG26 MCU_. The Explorer Kit is focused on rapid prototyping and concept creation of IoT
applications.
.. _EFM32PG26 Explorer Kit: https://www.silabs.com/development-tools/mcu/32-bit/efm32pg26-explorer-kit
.. _EFM32PG26 MCU: https://www.silabs.com/wireless/zigbee/efr32mg26-series-2-socs
Hardware
For more information about the EFM32PG26 MCU and Explorer Kit, refer to these documents:
EFM32PG26 Datasheet_EFM32PG26 Reference Manual_PG26-EK2711A User Guide_.. _EFM32PG26 Datasheet: https://www.silabs.com/documents/public/data-sheets/efm32pg26-datasheet.pdf
.. _EFM32PG26 Reference Manual: https://www.silabs.com/documents/public/reference-manuals/efm32pg26-rm.pdf
.. _PG26-EK2711A User Guide: https://www.silabs.com/documents/public/user-guides/ug608-brd2711a-user-guide.pdf
.. zephyr:board-supported-hw::
The EFM32PG26 MCU is configured to use the HFRCODPLL oscillator at 78 MHz as the system clock, locked to the 39 MHz crystal oscillator on the board.
The EFM32PG26 MCU has 3 USARTs and 4 EUSARTs. USART0 is connected to the board controller and is used for the console.
Programming and Debugging
.. zephyr:board-supported-runners::
Connect the Explorer Kit to your host computer using the USB port.
Here is an example for the :zephyr:code-sample:hello_world application.
.. zephyr-app-commands:: :zephyr-app: samples/hello_world :board: pg26_ek2711a :goals: flash
Open a serial terminal (minicom, putty, etc.) with the following settings:
Reset the board and you should see the following message in the terminal:
.. code-block:: console
Hello World! pg26_ek2711a