boards/shields/seeed_w5500/doc/index.rst
.. _seeed_w5500:
Seeed W5500 Ethernet Shield ###########################
Overview
Seeed W5500 Ethernet Shield_ is an Arduino connector shield with:
W5500_ 10/100 MBPS stand alone Ethernet controller with on-board MAC & PHY
and 16 KiloBytes for FIFO buffer,.. figure:: seeed_w5500.webp :align: center :alt: Seeed W5500 Ethernet Shield
Seeed W5500 Ethernet Shield
+-----------------------+---------------------------------------------+ | Shield Connector Pin | Function | +=======================+=============================================+ | RST | Ethernet Controller's Reset | +-----------------------+---------------------------------------------+ | D2 | Ethernet Controller's Interrupt Output | +-----------------------+---------------------------------------------+ | D10 | SPI's Chip Select | +-----------------------+---------------------------------------------+ | D11 | SPI's Master Output Slave Input (MOSI) | +-----------------------+---------------------------------------------+ | D12 | SPI's Master Input Slave Output (MISO) | +-----------------------+---------------------------------------------+ | D13 | SPI's Clock | +-----------------------+---------------------------------------------+
Requirements
This shield can only be used with a board that provides a configuration
for Arduino connectors and defines node aliases for SPI and GPIO interfaces
(see :ref:shields for more details).
Programming
Set --shield seeed_w5500 when you invoke west build. For example:
.. zephyr-app-commands:: :zephyr-app: samples/net/dhcpv4_client :board: nrf52840dk/nrf52840 :shield: seeed_w5500 :goals: build
References
.. target-notes::
.. _W5500: https://wiznet.io/products/iethernet-chips/w5500
.. _W5500 Ethernet Shield: https://wiki.seeedstudio.com/W5500_Ethernet_Shield_v1.0