boards/shields/mikroe_eth_click/doc/index.rst
.. _mikroe_eth_click:
MikroElektronika ETH Click ##########################
Overview
ETH Click is an accessory board in mikroBus™ form factor. It features ENC28J60,
a 28-pin, 10BASE-T stand alone Ethernet Controller with an on-board MAC & PHY,
8K Bytes of Buffer RAM and SPI serial interface.
More information at Eth Click Shield website.
+-----------------------+---------------------------------------------+ | Shield Connector Pin | Function | +=======================+=============================================+ | RST# | Ethernet Controller's Reset | +-----------------------+---------------------------------------------+ | CS# | SPI's Chip Select | +-----------------------+---------------------------------------------+ | SCK | SPI's ClocK | +-----------------------+---------------------------------------------+ | SDO | SPI's Slave Data Output (MISO) | +-----------------------+---------------------------------------------+ | SDI | SPI's Slave Data Input (MISO) | +-----------------------+---------------------------------------------+ | INT | Ethernet Controller's Interrupt Output | +-----------------------+---------------------------------------------+
Requirements
This shield can only be used with a board which provides a configuration
for Mikro-BUS connectors and defines node aliases for SPI and GPIO interfaces
(see :ref:shields for more details).
Programming
Set --shield mikroe_eth_click when you invoke west build. For example:
.. zephyr-app-commands:: :zephyr-app: samples/net/dhcpv4_client :board: lpcxpresso55s69 :shield: mikroe_eth_click :goals: build
References
.. target-notes::
.. _Eth Click Shield website: https://www.mikroe.com/eth-click
.. _ENC28J60: https://www.microchip.com/wwwproducts/en/en022889