Back to Zephyr

Overview

boards/renesas/ek_ra2a1/doc/index.rst

4.4.02.6 KB
Original Source

.. zephyr:board:: ek_ra2a1

Overview


The EK-RA2A1 is an evaluation kit for Renesas RA2A1 Microcontroller Group.

Renesas RA2A1 Microcontroller Group has following features

  • 48MHz, Arm Cortex-M23 core
  • 256kB Code Flash, 8kB Data Flash, 32kB SRAM
  • USB 2.0 Full-Sppeed
  • SCI x 3
  • SPI x 2
  • I2C x 2
  • CAN x 1
  • 16-bit A/D Converter
  • 24-bit Sigma-Delta A/D Converter
  • 12-bit D/A Converter
  • 8-bit D/A Converter x 2
  • High-Speed Analog Comparator
  • Low-Power Analog Comparator
  • OPAMP x 3
  • Temperature Sensor
  • General PWM Timer 32-bit x 1
  • General PWM Timer 16-bit x 6
  • Low Power Asynchronous General-Purpose Timer x 2
  • Watchdog Timer
  • 49 Input/Output pins

Hardware


Detail Hardware feature for the RA2A1 MCU group can be found at RA2A1 Group User's Manual Hardware_

.. figure:: ra2a1_block_diagram.webp :width: 442px :align: center :alt: RA2A1 MCU group feature

RA2A1 Block diagram (Credit: Renesas Electronics Corporation)

Detail Hardware feature for the EK-RA2A1 MCU can be found at EK-RA2A1 - User's Manual_

EK-RA2A1 has following features.

  • Native pin access through 4x 40-pin male headers
  • MCU current measurement points
  • SEGGER J-Link on-board programmer and debugger
  • Two Digilent Pmod (SPI and UART)
  • User LED
  • Mechanical user button
  • Capacitive user button

Supported Features

.. zephyr:board-supported-hw::

Programming and debugging


.. zephyr:board-supported-runners::

Building & Flashing

You can build and flash an application with onboard J-Link debug adapter. :ref:build_an_application and :ref:application_run for more details.

Here is an example for building and flashing the :zephyr:code-sample:blinky application.

.. zephyr-app-commands:: :zephyr-app: samples/basic/blinky :board: ek_ra2a1 :goals: build flash

Debugging

Debugging also can be done with onboard J-Link debug adapter. The following command is debugging the :zephyr:code-sample:blinky application. Also, see the instructions specific to the debug server that you use.

.. zephyr-app-commands:: :zephyr-app: samples/basic/blinky :board: ek_ra2a1 :maybe-skip-config: :goals: debug

References


.. target-notes::

.. EK-RA2A1 Web site: https://www.renesas.com/us/en/products/microcontrollers-microprocessors/ra-cortex-m-mcus/ek-ra2a1-evaluation-kit-ra2a1-mcu-group

.. _RA2A1 Group User's Manual Hardware: https://www.renesas.com/en/document/mah/renesas-ra2a1-group-users-manual-hardware

.. _EK-RA2A1 - User's Manual: https://www.renesas.com/en/document/mah/renesas-ra2a1-group-users-manual-hardware