.. zephyr:board:: kb1062_evb

Overview

The KB1062_EVB kit is a development platform to evaluate the ENE KB106X series microcontrollers. This board needs to be mated with part number KB1062.

Hardware

ARM Cortex-M3 Processor
256KB Flash and 64KB RAM
ADC & GPIO headers
SER serial port
FAN PWM interface
ENE Debug interface

Supported Features

.. zephyr:board-supported-hw::

System Clock

The KB106x MCU is configured to use the 48Mhz internal oscillator with the on-chip DPLL to generate a resulting EC clock rate of 48MHz/24MHz See Processor clock control register (refer 5.1 General Configuration)

Programming and Debugging

.. zephyr:board-supported-runners::

Flashing

If the correct headers are installed, this board supports SWD Debug Interface.

To flash with SWD, install the drivers for your programmer, for example: SEGGER J-link's drivers are at https://www.segger.com/downloads/jlink/

Debugging

Use SWD with a J-Link

References

.. target-notes::