ContextQMD
Back to Zephyr

Overview

boards/adafruit/feather_stm32f405/doc/index.rst

4.4.02.8 KB
Original Source

.. zephyr:board:: adafruit_feather_stm32f405

Overview

The Adafruit Feather STM32F405 is an ARM Development board in the Feather standard layout, sharing peripheral placement with other devices labeled as Feathers or FeatherWings. The board is equipped with a lithium ion battery charger, native USB C connector, 2MB of external flash memory, and SD card socket.

Hardware

  • STM32F405 Cortex M4 with FPU and 1MB Flash, 168MHz speed
  • 192KB RAM total - 128 KB RAM + 64 KB program-only/cache RAM
  • USB C power and data
  • LiPo connector and charger
  • SD socket on the bottom, connected to SDIO port
  • 2 MB SPI Flash chip
  • Built in NeoPixel indicator
  • I2C, UART, GPIO, ADCs, DACs
  • Qwiic/STEMMA-QT connector for fast I2C connectivity
  • SWD SMT mount region on board underside.

Supported Features

.. zephyr:board-supported-hw::

Connections and IOs

The Adafruit Feather STM32F405 Express Learn site_ has detailed information about the board including pinouts_ and the schematic_.

System Clock

The STM32F405 is configured to use the 12MHz HSE Oscillator to produce a 168MHz system clock.

Serial Port

The STM32F405 UART 3 peripheral is available on the TX (PB10) and RX (PB11) pins.

I2C Port

The STM32F405 I2C1 peripheral is available on the SDA (PB7) and SCL (PB6) pins.

SPI Port

The STM32F405 SPI2 peripheral is available on the SCK (PB13), MI (PB14) and MO (PB15) pins.

SPI1 uses SCK (PB3), MI (PB4), MO (PB5) and SS (PA15) pins and is dedicated to the 2 MB SPI Flash chip.

Programming and Debugging

.. zephyr:board-supported-runners::

DFU-Util programming is supported through Zephyr by default. Set up of the built in DFU-Util bootloader is possible by following the instructions on the Learn website_.

Flashing

#. Build the Zephyr kernel and the :zephyr:code-sample:blinky sample application:

.. zephyr-app-commands:: :zephyr-app: samples/basic/blinky :board: adafruit_feather_stm32f405 :goals: build :compact:

#. On the Adafruit Feather STM32F405, connect the 3.3V pin to the B0 boot pin with a jumper wire.

#. Flash the image:

.. zephyr-app-commands:: :zephyr-app: samples/basic/blinky :board: adafruit_feather_stm32f405 :goals: flash :compact:

You should see the D13 LED blinking.

References

.. target-notes::

.. _Adafruit Feather STM32F405 Express Learn site: https://learn.adafruit.com/adafruit-stm32f405-feather-express/

.. _pinouts: https://learn.adafruit.com/adafruit-stm32f405-feather-express/pinouts

.. _schematic: https://learn.adafruit.com/adafruit-stm32f405-feather-express/downloads

.. _instructions on the Learn website: https://learn.adafruit.com/adafruit-stm32f405-feather-express/dfu-bootloader-details