ENS210

Arduino library for the ENS210 temperature & humidity sensor with I2C interface from ScioSense

Introduction

This project is an Arduino library. It implements a driver with examples for the ENS210. The ENS210 chip is a digital temperature & humidity sensor with an I2C interface. The driver in this Arduino library is based on the code supplied by Sciosense, the manufacturer of the chip.

Note that the ENS210 requires a supply voltage of 1.71V .. 1.98V.

Links

The ENS210 is made by Sciosense.

• The datasheet of the ENS210 is not yet released

Prerequisites

It is assumed that

• The Arduino IDE has been installed. If not, refer to "Install the Arduino Desktop IDE" on the Arduino site.
• The library directory is at its default location. For me, Christoph, that is C:\Users\christoph\Documents\Arduino\libraries.

Build an example

To build an example sketch

• (Re)start Arduino.
• Open File > Example > Examples from Custom Libraries > ENS210 > ENS210basic.
• Make sure Tools > Board lists the correct board.
• Select Sketch > Verify/Compile.