boards/cc1312-launchpad/doc.md
@defgroup boards_cc1312_launchpad TI CC1312 LaunchPad @ingroup boards @brief Texas Instruments SimpleLink(TM) CC1312 Wireless MCU LaunchPad(TM) Kit
The LAUNCHXL-CC1312R1 is a Texas Instrument's development kit for the CC1312R1 SoC MCU which combines a Cortex-M4F microcontroller alongside a dedicated Cortex-M0 to control radio.
| MCU | CC1312R1 |
|---|---|
| Family | ARM Cortex-M4F |
| Vendor | Texas Instruments |
| RAM | 80KiB |
| Flash | 352KiB |
| Frequency | 48MHz |
| FPU | yes |
| Timers | 4 |
| ADCs | 1x 12-bit (channels) |
| UARTs | 2 |
| SPIs | 2 |
| I2Cs | 1 |
| Vcc | 1.8V - 3.8V |
| Datasheet | Datasheet (pdf file) |
| Reference Manual | Reference Manual |
The LAUNXHL-CC1312R Quick Start Guide provides the default pinout for the board.
Flashing RIOT is quite straight forward. The board comes with an XDS110 on-board debug probe that provides programming, flashing and debugging capabilities through the USB Micro-USB connector. Once either TI Uniflash or OpenOCD are installed just connect the board using the Micro-USB port to your computer and type:
BOARD=cc1312-launchpad make flash
To use OpenOCD instead of uniflash we need to set the PROGRAMMER environment
variable, this is to enable OpenOCD instead of Uniflash.
PROGRAMMER=openocd BOARD=cc1312-launchpad make flash
For detailed information about CC1312 MCUs as well as configuring, compiling RIOT and installation of flashing tools for CC1312 boards, see \ref cc26xx_cc13xx_riot.