boards/nucleo-f030r8/doc.md
@defgroup boards_nucleo-f030r8 STM32 Nucleo-F030R8 @ingroup boards_common_nucleo64 @brief Support for the STM32 Nucleo-F030R8
The Nucleo-F030R8 is a board from ST's Nucleo family supporting a ARM Cortex-M0 STM32F030R8 microcontroller with 8KiB of RAM and 64KiB of Flash.
You can find general information about the Nucleo64 boards on the @ref boards_common_nucleo64 page.
@image html pinouts/nucleo-f030r8.svg "Pinout for the Nucleo-F030R8 from STM user manual UM1724, http://www.st.com/resource/en/user_manual/dm00105823.pdf, page 28)" width=50%
| MCU | STM32F030R8 |
|---|---|
| Family | ARM Cortex-M0 |
| Vendor | ST Microelectronics |
| RAM | 8KiB |
| Flash | 64KiB |
| Frequency | up to 48MHz |
| FPU | no |
| Timers | 10 (2x watchdog, 1 SysTick, 7x 16-bit) |
| ADCs | 1x 12-bit |
| UARTs | 2 |
| SPIs | 2 |
| I2Cs | 2 |
| RTC | 1 |
| Vcc | 2.4V - 3.6V |
| Datasheet | Datasheet |
| Reference Manual | Reference Manual |
| Programming Manual | Programming Manual |
| Board Manual | Board Manual |
| Device | ID | Supported | Comments |
|---|---|---|---|
| MCU | STM32F030R8 | partly | Energy saving modes not fully utilized |
| Low-level driver | GPIO | yes | |
| PWM | yes (4 pins available) | ||
| UART | 2 UARTs | USART2 via STLink/USB or D0(RX)/D1(TX) and USART1 on PA10(RX)/PA09(TX) | |
| ADC | 6 pins | ||
| I2C | no | ||
| SPI | no | ||
| USB | no | ||
| Timer | 3 16 bit timers |
A detailed description about the flashing process can be found on the
guides page.
The board name for the Nucleo-F030R8 is nucleo-f030r8.