studiokestra/galatea

TKL H87/88c compatible PCB with support for the most common layouts.

• Keyboard Maintainer: Studio Kestra
• Hardware Supported: Most H87C compatible keyboards
• Hardware Availability: https://RNDKBD.com; https://geon.works/
• Rev1 firmware is used for Galatea PCBs with no RGB underglow.
• Rev2 firmware is used for Galatea PCBs with RGB underglow.
• Rev3 firmware is used for Galatea PCBs with RP2040 chip w/ RGB underglow.

Make example for this keyboard (after setting up your build environment):

make studiokestra/galatea/rev1:default

Flashing example for this keyboard:

make studiokestra/galatea/rev1:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

• Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
• Physical reset button: Briefly press the button on the back of the PCB - some may have pads you must short instead
• Keycode in layout: Press the key mapped to QK_BOOT if it is available