stardustn0

This project is a custom-built split ergonomic mechanical keyboard, using two Raspberry Pi Pico microcontrollers.

• Keyboard Maintainer: navidyt
• Hardware Supported: Raspberry Pi Pico, MX switches, Gateron hot-swap sockets, 1N4148 diodes, generic USB-C breakout board

Make example for this keyboard (after setting up your build environment):

make stardustn0:default

Flashing example for this keyboard:

make stardustn0:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

• Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
• Physical reset button: Briefly press the reset button on the pico while connecting USB
• Keycode in layout: Press the key mapped to QK_BOOT if it is available