Aurora Sweep's Debug Keymap

Due to the complex layer setup, the default keymap for the Aurora Sweep is relatively hard to debug. This debug keymap should make that a lot easier.

Keys

The left side uses lowercase letters, the right side uses uppercase ones.

Encoders

Encoders output a number of 0 to 3, depending on the installed position. These correspond to the index used for custom encoder code.

The number is followed by either a + or a -, depending on the direction turned.

LEDs

Both underglow and per-key RGB should be fading between red and off.

OLEDs

Both the primary and secondary side should be filled with characters.