Teton 78 QMK Firmware

Introduction

This is the QMK firmware repository for the Teton78, a 68XT solder and hotswao keyboard designed by Mountain Mech Designs - Bennett Balogh.

The Teton 78 has entered GB and sucessfully finalized in November 2024 The IC page for the keyboard can be found here. The sale page can be found here Discord link can be found here

About

Keyboard Maintainer: Bennett Balogh
Hardware Supported: Atmega32u4
Hardware Availability: N/A

How to compile

After setting up your build environment, you can compile the Teton 78 default keymap by using:

make mountainmechdesigns/teton_78:default

Flash using

make mountainmechdesigns/teton_78:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
Physical reset button: Briefly press the button on the back of the PCB - some may have pads you must short instead
Keycode in layout: Press the key mapped to QK_BOOT if it is available