Promenade RP24S

The Promenade RP24S is the solder version of the Promenade pcb which is based on the Boardwalk, a 60% ortholinear keyboard that uses 1.5u Ergodoxian modifier keys. The original Boardwalk's split hand and 65% layouts are supported, and a new 50% extended layout similar to RGBKB's Pan with two right-side macro columns was also added. In addition to Pok3r-style 60% tray mounting points, the pcb also has edge cuts for use in gummy o-ring mount boards like the Bakeneko60. Some additional spacebar options including 3u, 6u, and triple 2u were added. The pcb has two footprint locations for a JST connector, many breakout pins, and 19 rotary encoder locations. The MCU has been upgraded to a RP2040 with 32M-bit of flash memory.

• Keyboard Maintainer: Feags / Krado Industries
• Hardware Supported: Promenade pcb. Many 60% cases.
• Hardware Availability: Krado Industries

Make example for this keyboard (after setting up your build environment):

make kradoindustries/promenade_rp24s:default

Flashing example for this keyboard:

make kradoindustries/promenade_rp24s:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

• Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
• Physical reset button: Briefly press the button on the back of the PCB - some may have pads you must short instead
• Keycode in layout: Press the key mapped to QK_BOOT if it is available