Drashna's Blackpill Tractyl Manuform (5x6) with a right side trackball

System Timer on TIM5
VBUS mod, using PB10 -- does work, but not on my tractyl... bad soldering probably
Split Hand Pin, using PC14
Full Duplex Serial/USART using PA2 and PA3 on USART2
PWM Audio using PB1 and TIM3 and GPT on TIM4
PWM WS2812 RGB using PA1 TIM2
8KB SPI EEPROM chip sharing PA5-PA7 on SPI1 with PA4 as CS pin
pmw3360 sensor sharing PA5-PA7 on SPI1, with B0 as CS pin
Encoder using PA13 and PA14
SSD1306 OLED display (128x64) using PB8-PB9 on I2C1
Pull-up resistor (22k) on PA10 to fix reset issue.
Pull-up resistor (5.1k) on PA1 for WS2812 LED support, and wire it's VCC to the 5V pin.
Pins PA9 is meant for VBUS sense, and has an internal pulldown resistor. A 5.1k pullup resistor can work (but should be avoided)
Pins PA11 and A12 are not useable because they're used for USB connection, and can't be shared.
Pin PB2 is used by BOOT1, and is unusable

Keyboard Info

Make example for this keyboard (after setting up your build environment):

make handwired/tractyl_manuform/5x6_right/f411:default

Flashing example for this keyboard:

make handwired/tractyl_manuform/5x6_right/f411:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootmagic reset: Hold down the top right key on the right side, or the top left key on the left side while plugging in.
Physical reset button: Briefly press the "USER" button on the BlackPill
Keycode in layout: Press the key mapped to QK_BOOT.