dactyl_manuform_pi_pico

This is a dactyl_manuform 5x6 running Rasrberry Pi Pico. It's based on alcor_dactyl but with more reasonable GPIO layout for Pi Pico and clasic dactyl_manuform layout (pinkies have only 4 rows).

Build instructions: https://github.com/GustawXYZ/dactyl_manuform_pi_pico/

• Keyboard Maintainer: Gustaw.xyz
• Hardware Supported: Raspberry Pi Pico and other RP2040
• Hardware Availability: https://www.raspberrypi.com/products/raspberry-pi-pico/
• 3D Print model: https://github.com/abstracthat/dactyl-manuform

Make example for this keyboard (after setting up your build environment):

make handwired/dactyl_manuform_pi_pico:default

Flashing example for this keyboard:

make handwired/dactyl_manuform_pi_pico:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

• Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
• Physical reset button: Briefly press the button on the back of the PCB - some may have pads you must short instead
• Keycode in layout: Press the key mapped to QK_BOOT if it is available