5x6_split revision 1

This is the first revision of the 5x6_split keyboard.

The 5x6_split is designed to be easily accessible, with openly and freely available hardware and firmware. It features a split layout to minimize the PCB footprint, reducing manufacturing costs. Like the Ergodox, it allows you to keep your hands at shoulder width for a more natural typing posture, but without a thumb cluster, making it a better option for users who experience discomfort or limitations in their thumbs.

The keyboard is also designed with ergonomics in mind. Its low profile, measuring just 19.4 mm from the table to the top of the keycaps (including rubber feet), helps reduce wrist strain during extended use.

In the repository linked below (see the Hardware Availability section), you will find KiCad schematics, PCB designs, and 3D models for a printable chassis.

Keyboard Maintainer: wholteza
Hardware Supported: Raspberry Pi Pico, 5x6_split PCB, 5x6_split Chassis
Hardware Availability: PCB, Chassi 3d-models

Make example for this keyboard (after setting up your build environment):

make handwired/5x6_split/rev1:default

Flashing example for this keyboard:

make handwired/5x6_split/rev1:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
Physical reset button: Briefly press the button on the back of the PCB - some may have pads you must short instead
Keycode in layout: Press the key mapped to QK_BOOT if it is available