Flame60

The Flame60 consists of a screwless exterior, flex cut pcb and plate to ensure a soft typing experience.

• Keyboard Maintainer: CMM.Studio Freather
• Hardware Supported: Atmega32u4
• Hardware Availability: CLAP.STUDIO (Instagram)

Make example for this keyboard (after setting up your build environment):

make clap_studio/flame60:default

Flashing example for this keyboard:

make clap_studio/flame60:default:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

Bootloader

Enter the bootloader in 3 ways:

• Bootmagic reset: Hold down the key at (0,0) in the matrix (usually the top left key or Escape) and plug in the keyboard
• Physical reset button: Briefly press the button on the back of the PCB - some may have pads you must short instead
• Keycode in layout: Press the key mapped to QK_BOOT if it is available