ContextQMD
Back to Qmk Firmware

Yakiimo Rev A

keyboards/4pplet/yakiimo/readme.md

4.01.1 KB
Original Source

Yakiimo Rev A

  • Keyboard Maintainer: 4pplet
  • Hardware Supported: Yakiimo Rev A

Make example for this keyboard (after setting up your build environment):

make 4pplet/yakiimo/rev_a:via:flash

See the build environment setup and the make instructions for more information. Brand new to QMK? Start with our Complete Newbs Guide.

How to enter bootloader (DFU):

  • Press and hold the button on the keyboard (the small one on the same side as the MCU) for more than 1 second. The keyboard will then enter bootloader (DFU) mode and it's ready to flash the firmware.
  • Note: If holding the button a shorter time, the keyboard will just reset. If you want to exit bootloader mode without flashing a firmware, dissconnect the keyboard from your PC and reconnect it.

Alternative option if the firmware is already pre-flashed:

  • Unplug your keyboard, hold down the Spacebar and B at the same time, plug in your keyboard and wait a second before releasing the keys. Bootmagic lite is enabled by default.