Back to Mremoteng

Port Scan

mRemoteNGDocumentation/user_interface/port_scan.rst

2025.03.30-v1.78.2-nb906 B
Original Source

.. _port_scan:


Port Scan


The Port Scan feature (under Tools > Port Scan) is similar to a nmap port scan. It will scan a range of IP addresses and to determine if specific mRemoteNG supported protocols are active. Hosts can then be bulk imported into mRemoteNG.

.. tip::

If you leave this at the default of 0 & 0, the test will be for the default protocol ports that mRemoteNG supports.
  • Start the Port Scan feature by clicking Tools > Port Scan in the menu bar.
  • Input your Start IP and End IP of the range you'd like to scan.
  • Enter the Start Port and End Port that mRemoteNG should test for.
  • Click Scan
  • Wait. Possibly a long time.
  • The table will populate, and eventually you'll get a notification that the scan has completed. Alternatively, you can press Stop to end the scan at any time.
  • Change the dropdown to the protocol you'd like to import and click Import.