ContextQMD
Back to Micropython

Board

ports/esp32/boards/ESP32_GENERIC/board.md

1.28.0979 B
Original Source

The following files are firmware that should work on most ESP32-based boards with 4MiB or more of flash, including WROOM WROVER, SOLO, PICO, and MINI modules.

This board has multiple variants available:

  • If your board is based on a WROVER module, or otherwise has SPIRAM (also known as PSRAM) then it's recommended to use the "spiram" variant. Look for heading Support for SPIRAM / WROVER).
  • If your board has a ESP32-D2WD chip (with only 2MiB flash) then use the "d2wd" variant. Look for heading ESP32 D2WD.
  • If your board has a single-core ESP32 (e.g. the "SOLO" modules) then choose the "unicore" variant. Look for heading ESP32 Unicore.
  • If you'd like to perform Over-the-Air updates of the MicroPython firmware, then choose the "ota" variant. This variant has less room in the flash for Python files as a result of supporting OTA. Look for heading Support for OTA.

Otherwise, download the generic variant (under the first heading below).