Zstumbler

Actively scans the Zigbee channels by sending a beacon broadcast packet and listening for responses.

Options

DEVICE

ZigBee Device ID. Defaults to the target device that is specified via the target command or if one device is presented when running 'supported_devices' it will use that device.

CHANNEL

The channel to scan. Setting this options will prevent the stumbler from changing channels. Range is 11-26, inclusive. Default: not set n

LOOP

How many times to loop over the channels. Specifying a -1 will loop forever. Default: 1

DELAY

The delay in seconds to listen to each channel. Default: 2

Scenarios

Scanning channel 11 for other ZigBee devices in the area.

hwbridge > run post/hardware/zigbee/zstumbler channel=11

[*] Scanning Channel 11
[*] New Network: PANID: 0x4724 SOURCE: 0x25D5
[*]         Ext PANID: 6E:03:C7:74:31:E2:74:AA       Stack Profile: ZigBee Enterprise
[*]         Stack Version: ZigBee 2006/2007
[*]         Channel: 11
[*] New Network: PANID: 0x4724 SOURCE: 0x7DD1
[*]         Ext PANID: 6E:03:C7:74:31:E2:74:AA       Stack Profile: ZigBee Enterprise
[*]         Stack Version: ZigBee 2006/2007
[*]         Channel: 11