Back to Esp Idf

ULP-RISC-V DS18B20 Temperature Sensor OneWire Communication

examples/system/ulp/ulp_riscv/ds18b20_onewire/README.md

6.1-dev1.2 KB
Original Source
Supported TargetsESP32-S2

ULP-RISC-V DS18B20 Temperature Sensor OneWire Communication

This example demonstrates how to program the ULP-RISC-V co-processor to read temperature from a DS18B20 temperature sensor over 1-Wire. When the measurement exceeds the limit set(32.5 degrees) the co-processor will wake up the main CPU from deep-sleep and the main CPU will print the temperature measurement.

Hardware Required

  • A development board with a SOC which has a RISC-V ULP coprocessor (e.g., ESP32-S2 Saola)
  • A USB cable for power supply and programming
  • A DS18B20 temperature sensor

Example connection :

ESP Dev-kitDS18B20
GPIO4DQ
VCC 3.3VVDD
GNDGND

Example output

Not a ULP wakeup, initializing it!
Entering in deep sleep

...

ULP-RISC-V woke up the main CPU, temperature is above set limit!
ULP-RISC-V read temperature is 32.562500
Entering in deep sleep

...

ULP-RISC-V woke up the main CPU, temperature is above set limit!
ULP-RISC-V read temperature is 33.000000
Entering in deep sleep