Nucleo-H563ZI Mongoose Integration

This guide explains how to bring up a production-grade Web UI dashboard on the STM32 Nucleo-H563ZI development board.

A pre-configured, ready-to-run project zip is available for download at https://mongoose.ws.

To integrate the Web UI dashboard into an existing CubeMX project, or to create a new project from scratch:

1. Configure the peripherals (described below).
2. Regenerate your project code and integrate Mongoose core by following https://mongoose.ws/docs/guides/stm32-tcpip-stack/.
3. Add the Web UI dashboard by following https://mongoose.ws/docs/guides/web-dashboard-guide/.

Configure peripherals

An .ioc file is included in this directory for your reference. It was created using the following steps:

• Open CubeMX. If you are starting a new project, select the STM32H563ZI microcontroller and create a new project.
• In Pinout & Configuration / Security, enable RNG and select "Activated".
• In Clock Configuration, set the maximum clock frequency to 250 MHz.
• In the MCU pinout view, set pins PB0, PF4, and PG4 to GPIO_Output mode.
• In Pinout & Configuration / Connectivity, enable USART3 in asynchronous mode. Configure pins PD8 and PD9 for USART.
• In Pinout & Configuration / Connectivity, enable ETH in RMII mode and set pins PA1, PA2, PA7, PC1, PC4, PC5, PB15, PG11, and PG13 for Ethernet.