javav2/example_code/mq/README.md
This README discusses how to run and test the Java code examples for Amazon MQ..
IMPORTANT
The Java examples perform AWS operations for the account and AWS Region for which you've specified credentials, and you may incur AWS service charges by running them. See the AWS Pricing page for details about the charges you can expect for a given service and operation.
Some of these examples perform destructive operations on AWS resources, such as deleting a message. Be very careful when running an operation that deletes or modifies AWS resources in your account. It's best to create separate test-only resources when experimenting with these examples.
To run these examples, you can setup your development environment to use Apache Maven or Gradle to configure and build AWS SDK for Java projects. For more information, see Get started with the AWS SDK for Java 2.x.
You can test the Amazon MQ Java code examples by running a test file named AmazonMQTest. This file uses JUnit 5 to run the JUnit tests and is located in the src/test/java folder. For more information, see https://junit.org/junit5/.
You can execute the JUnit tests from a Java IDE, such as IntelliJ, or from the command line by using Maven. As each test is executed, you can view messages that inform you if the various tests succeed or fail. For example, the following message informs you that Test 3 passed.
Test 3 passed
WARNING: Running these JUnit tests manipulates real Amazon MQ resources and may incur charges on your account.
Before running the Amazon MQ JUnit tests, you must define values in the config.properties file located in the resources folder. This file contains values that are required to execute the JUnit tests. For example, you define a broker name used for various tests. If you do not define all values, the JUnit tests fail.
Define these values to successfully run the JUnit tests:
engineType - The enum of your selected broker engine type. Accepted values are ACTIVEMQ and RABBITMQ.
brokerName – The name for a new Amazon MQ broker. For example, MyNewBroker.
configurationName – The name for a new Amazon MQ broker configuration. For example, MyNewConfiguration.
brokerId - The unique ID of an existing ActiveMQ broker where configuration changes will be applied.
configurationId - The unique ID of an existing ActiveMQ XML configuration to be associated with the specified broker.
To run the JUnit tests from the command line, you can use the following command.
mvn test
You will see output from the JUnit tests, as shown here.
[INFO] -------------------------------------------------------
[INFO] T E S T S
[INFO] -------------------------------------------------------
[INFO] Running AmazonMQtest
Running Amazon MQ Test 1
Running Amazon MQ Test 2
...
Done!
[INFO] Results:
[INFO]
[INFO] Tests run: 7, Failures: 0, Errors: 0, Skipped: 0
[INFO]
INFO] --------------------------------------------
[INFO] BUILD SUCCESS
[INFO]--------------------------------------------
[INFO] Total time: 12.003 s
[INFO] Finished at: 2021-02-18T09:25:08-05:00
[INFO] --------------------------------------------
If you do not define the correct values in the properties file, your JUnit tests are not successful. You will see an error message such as the following. You need to double-check the values that you set in the properties file and run the tests again.
[INFO]
[INFO] --------------------------------------
[INFO] BUILD FAILURE
[INFO] --------------------------------------
[INFO] Total time: 19.038 s
[INFO] Finished at: 2020-02-10T14:41:51-05:00
[INFO] ---------------------------------------
[ERROR] Failed to execute goal org.apache.maven.plugins:maven-surefire-plugin:2.22.1:test (default-test) on project S3J2Project: There are test failures.
[ERROR];